What is the difference between a motorized and a manual roll out sheet metal rack? A motorized rack extends its drawers under electric power from a remote and carries up to 20,000 kg per level on the largest platform. A manual rack uses a crank handle, typically with a ceiling around 5,000 kg per level, and needs the operator at the rack face during extension.
Can one person retrieve a sheet? Yes, for the storage step. One operator selects the tier, the drawer extends, and the crane lifts the sheet. The second person who would hold and guide a manual drawer is no longer needed.
What sheet sizes does it take? From 3,000 x 1,500 mm to 12,000 x 2,500 mm across five models, with five or six tiers and 120 mm clear space as standard.
Can one rack store both steel and aluminum? Yes. Aluminum goes on dedicated tiers with a non-marking deck and separators, steel on the remaining tiers, and clear space is set for the tallest stack rather than the heaviest.
How tall can a unit be built? Five or six tiers are standard and customizable. Final height follows tier count and clear space, checked against crane hook height before the drawing is released.
Does the drawer work with an overhead crane only? Overhead cranes are the main case, and forklifts cover smaller sheets and pallet moves. The drawer takes the horizontal travel, so the lifting device only works vertically.
What is the difference between an electric and a manual roll out plate drawer? The electric drawer carries more weight and extends under power, with travel on a remote. Herochu rates these tiers from 3,000 kg to 20,000 kg. A manual crank rack typically stops around 5,000 kg per level and needs an operator at the handle for every extension.

How long does one pick take? Drawer travel is up to 5.27 m/min, so a six metre drawer reaches full extension in a little over a minute while the crane is still approaching. The lift itself is unchanged.
Can the system work with a forklift instead of a crane? Yes, for sheets within the truck’s capacity and fork length. The drawer removes the horizontal pull, so the forklift only lifts and reverses.
How much can one tier hold? 3,000 kg on the HC-B3015E-63, HC-B4015E-63 and HC-B4020E-63, 5,000 kg on the HC-B6015E-65, and 20,000 kg on the HC-B12025E-520. A heavier rating changes the frame and the drive, not just the label.
Can steel, stainless and aluminum share one rack? Yes. Separation by tier keeps grades apart, and a non-marking deck protects soft aluminum and polished stainless from the scuffs that come with steel-on-steel contact.
Does the drawer need a crane to open? No. Drawer travel is electric and runs from a remote handset. The crane or forklift is only needed to lift the sheet off the deck.
How much floor space does it save? A six-tier bay holds six sheet piles in the footprint of one, plus a drawer extension zone. Against floor stacking, most of the gain shows up as clear aisle space and direct access rather than raw square metres.









