What is a crank-out cantilever rack?
A cantilever system whose arm receptacles travel out of the frame on a hand-cranked shaft drive, giving 100% extension for overhead lifting. Herochu builds them as single or double-sided frames, generally to eight levels.
How much weight can one arm carry?
Capacity is engineered per project, not read from a table. Arm length, bundle weight, load centre and the number of loaded arms on a shaft set the section and drive, which Herochu confirms against real bundle weights.
Does the crank take much effort?
Little. It moves a loaded receptacle on rollers, so effort follows rolling resistance and gear ratio rather than tonnage. Heavier columns get a higher reduction instead of a longer handle.
How much floor space does it save?
Plants replacing floor stacks and static racks with roll-out units report up to five times the storage capacity on the same footprint, mainly by using height and by serving double-sided units from one aisle.
Herochu has engineered material storage for metalworking plants for 16 years, building every frame in-house and load-testing it before dispatch. Send the pipe schedule, bundle weights and a bay drawing to start sizing.
Can one rack hold pipe, tube and bar stock together?
Yes, within the load case. Dividers and separate levels let one bay carry different profiles, and Herochu sets arm spacing and level gaps per group so a heavy bundle does not share a level with light tube.
Is a hand crank realistic for heavy bundles?
For most pipe stores it is, because the crank moves the receptacle on rollers instead of lifting it. Where bundle weight exceeds what a manual drive should move, the bay is specified with lift integration or a powered drive.
Can the rack be extended later?
It can be designed for it. Frames are modular, so an approved layout can reserve aisle space and foundation for a second unit, and matching frames can be added without rebuilding the first.
How is the rack installed?
Frames are set on prepared base plates, anchored to the slab, then shafts, control panels and grid supports are fitted and the crank travel is checked empty before the first load.
Herochu has engineered storage for metalworking plants for 16 years, and every hand crank pipe storage rack is designed, built and load-tested in-house. Start with the pipe schedule and the heaviest bundle; the first layout comes back with levels, arm lengths and drive ratios marked, and the quote follows that drawing.










